• Federal and State Government
• Deptartment of Transportation
• Private Industry
• Apartment Buildings
• Shopping Centers
• Condo Units
• Private Homes with Flat Roofs

Seamless Composition
The SPF System Consists of Two Compositions:

A seamless (monolithic) blanket of rigid, sprayed-in-place, water resistant, polyurethane foam membrane which fills in low areas and seals your roof at the desired thickness.
Once cured, the SPF is then protected by a sprayed-on, seamless, Ultra-violet resistant membrane coating.

This SPF Roofing System eliminates the problems of seams and joints with a continuous, seamless, fully insulated blanket of 100% full adhesion to your existing roof.

Lightweight
The average SPF Roofing System weighs less than 1 lb. per square foot. (Most other systems weigh 5-15 lbs. per square foot.)

Strong and Durable
SPF will allow normal roof traffic.
Maintenance is as easy as using a tube of caulk. There are no messy asphalts or tars, there is no gravel to sweep away and there are no saturated sheets to lift and look under.

Ease of Application
The average commercial roofing area can be re-roofed at the rate of approximately 30 to 100 squares per day. Professional, Courteous, Licensed approved applicators will incorporate roof needs at installation to provide on-site adjustments for extra needs, such as building up low areas, adding extra wall applications or creating slope so that water can be directed off the roof.

100% Adhesion
Since SPF Roofing is sprayed-in-place, it has a 100% chemical bond to any clean, dry surface:

• NO screw type fasteners which put holes in your existing roof.
• NO dangerous flame/torch-down membranes.
• NO glue-type adhesives which breakdown when under water.

Resists Lateral Water Movement
SPF is a 93% closed cell construction. Water cannot enter the foam and travel horizontally!
All other membrane roofing systems are made up of plies and porous insulation board which will allow water to travel through it very easily.

Reduces Thermal Shock
SPF has the highest R-Factor (R-7 per inch) of any roof insulation on the market today. This high R-Value resists heat build-up and conductivity greater than any other construction product. This allows the decking to stay cooler, thus eliminating excessive structural movement which causes most roof membranes to fail prematurely.
SPF can save you 30-40% on your heating and cooling costs.

Self-Flashing
Since SPF is sprayed-in-place, it bonds and seals all walls, curbs and penetrations in a continuous, seamless manner and forms it's own slope (to push water away from these troublesome areas). The insulating strength reduces expansion and contraction eliminating separation from walls, curbs and penetrations.
In all other systems, these are the weakest points and usually the first to fail.